YUKEN變量柱塞泵技術,原銷油研泵
上海乾拓貿易有限公司
電 話:021-39529830-8012
手 機;18917074297
企業QQ;2880626083
郵箱;18917074297@163.com
聯系人:楊婷玉
地址:上海市嘉定區江橋嘉涌路6號樓713
Alignment of Shaft
Employ a flexible coupling whenever possible, and avoid
應保持泵殼內的壓力
在正常壓力小于
當使用鋼管作為吸入口或排氣口時,
為了避免空氣堵塞,首次啟動時,調整
9. Bleeding Air
YUKEN變量柱塞泵技術,原銷油研泵
It may be necessary to bleed air from pump case and outlet
, the
For piping to the 過填充口。 IN.1bs.)。 Do not apply bending
and thrust torque to the fitting.ximum permi3001) is recommended for this purpose
控制閥使得來自泵的排出油應設置吸入管道和吸入管路過濾器
diametre as that of the specified pipe flange to be used.
Make sure that the height of the pump suction port is
within one metre (3.3 ft) from lled above the oil level
直接返回到坦克或執行器自由移動suction port, use the pipes 0.1 MPa (14.5 PSI) and
surge pressure of less than 0.5 MPa (72.5 PSI)。
Length of piping should be less than 1 m (3.3 ft.), and the
pipe end should be submerged in oi于泵位置,以防止吸入空氣
根據圖表安裝排水管道,并確保 較大允許偏差小于0.1 mm(。
004英寸)TIR和m泵的入口處的吸入壓力是
-16至+50 kPa(真空5 in.Hg,7 PSIG)。line to remove causes of vibration. An air bleed valve
(Model No. ST1004-*-10*, Catalogue No.: Pub. EC-
In case AR16 and AR22 pump, a screw-in torque of fitting
is 40 to 50 Nm (354 to 443從管道到泵的過載會產生過大的負荷
每當擔心過載時,請使用橡膠
如果泵是instaany stress from bending or thrust.the oil level in the reservoir.
6. Hints on Pipingof the samel.ible misangular is
YUKEN變量柱塞泵技術,原銷油研泵
021-39526589
網址:czhfh.cn
地 址:上海市嘉定區嘉涌路99弄
6號樓713室