出售日本YUKEN單向調速閥
上海乾拓貿易有限公司
企業QQ:2880626087
電話;021-69001039
手機;17321017802(微信)
郵箱;17321017802@163.com
地址:上海市嘉定區江橋嘉涌路99弄6號樓713室
Use hydraulic fluids which satisfy the recommended viscosity and oil temperatures given above.
Control of Contamination Due caution must be paid to maintaining control over contamination of the hydraulic fluids
which may otherwise lead to breakdowns and shorten the life of the valves.
Please maintain the degree of contamination within NAS 1638Grade 12. Use 25 μm or finer line filter.
需要進出口之間的小壓差來獲得較佳的壓力補償。
它根據要設置的流量而變化。參考性能曲線。閔。所需壓力差
務必使用10微米或更細的線路濾波器,并將其安裝在閥門入口附近。
污染控制必須注意保持對液壓油污染的控制,
止回閥壓降隨流速而變化。
通過使用這些閥,可以獲得加速或減速的無震動運行。
使用壓力和溫度的補償器,無論壓力(負載)
and Check Valves Flow control of these valves is continuously made
by a hydraulically operated pilot piston mechanism which controls opening area of the orifice of the valve.
With the use of these valves, shockless operation either in acceleration or deceleration can be obtained.
With the compensator for the pressure and temperature,
松開鎖定螺絲,順時針轉動流量調節手柄增加,逆時針方向減少。
內置旋轉指示器以數字刻度表示打開狀態(參考“流量與撥號位置”的特征)。
調整流量后,擰緊鎖緊螺絲。 [F * G-02,03,06,10]
要進行小于2L / min(.53UUGPM)以下的流量調節,
否則可能會導致故障的破壞并縮短閥門的使用壽命。
請保持NAS 1638Grade 12內的污染程度。
使用25μm或更細的線路濾波器。
Flow Control and Check Valves These valves are pressure and temperature compensating type valves
and maintain a constant flow rate independent of change in system pressure (load) and temperature (viscosity of the fluid).
They control flow r ate of the hydraulic circuit and eventually control speed of the actuator precisely.
如果使用帶止回閥的型號,參閱自由流壓降特性。自由流動
松開鎖緊螺絲,順時針轉動流量調節撥盤增加,逆時針方向減少。
表盤從零到全流大約轉4圈,旋轉指示器上顯示閥門開度。
(參考“量程與撥號位置的特征”)。調整流量后,擰緊鎖緊螺絲。
流量調節[F * G-01]
流量控制和止回閥,這些閥門是壓力和溫度補償型閥門,
可以獨立于系統壓力(載荷)和溫度(流體粘度)的變化保持恒定的流量。
它們控制液壓回路的流量并終控制執行器的速度。
stable flow control can be obtained regardless of the changes in the pressure (load) and temperature (oil viscosity).
Recommended Viscosity and Oil Temperatures 2 Viscosity ranging between 15 - 400 mm /s (77 - 1800 SSU).
Oil temperatures between -15/+70°C (5 - 158°F).
和溫度(油粘度)的變化如何,都可以獲得穩定的流量控制。
TJ的粘度和油溫2粘度范圍在15 - 400 mm / s(77 - 1800 SSU)之間。
油溫在-15 / + 70°C(5 - 158°F)之間。
使用滿足上述給出的TJ粘度和油溫的液壓油。
具有集成止回閥的閥門允許受控的和反向自由流量。
可以用數字讀數方便地重復復位。
Valves with an integral check valve allow a controlled f low and reverse free flow.
Repeated resetting can be made easily with a digital readout.
先導式流量控制和止回閥,這些閥門的流量控制
由液壓操作的先導式活塞機構連續地進行控制,閥的孔口。
出售日本YUKEN單向調速閥
021-39526589
網址:czhfh.cn
地 址:上海市嘉定區嘉涌路99弄
6號樓713室